Ask the wiki AIAI

Configuration guide peoplefone®

1. Configuration guide

This configuration guide describes how to set up a Behnke Station as a SIP extension of a peoplefone® cloud PBX. We are assuming that the basic configuration of the peoplefone® system has already been done, and we will only describe the steps required to register the Behnke Station with peoplefone®. We also assume that the Behnke station has already been integrated into the network and can be accessed via the IP address in a browser. It is assumed that the Behnke-Station is already set up to the extent that access to the web interface is possible. If this is not the case, please follow the instructions provided with your base electronics (manuals) and refer to the technical manualRecently updated — within the last 72 hoursUpdated to complete the basic setup.

1.1. Configuring the extension for the Behnke Station

Please note that the configuration of the extension is only shown very briefly and the configuration may vary for your peoplefone®. If in doubt, please contact your peoplefone® support.

Each Behnke Station must be registered manually on the cloud system. It is not possible to provision the Behnke Station.

• First, start the configuration interface of your cloud system in your browser and log in with your admin credentials.

• On the start page, click on "SIP Lines/Users" in the menu on the left, and then on "+ Add" to create a SIP user for the Behnke Station. You can find more information about this in the peoplefone® documentation.

• Then click on "SIP Setup" for the corresponding user. There you will see the necessary information for SIP registration of the Behnke Station. This information is required in the next step.

  The following section contains only the steps required to create a user. The setup may differ in your installation. If in doubt, please contact your PBX support.

1.2. Configuring the Behnke Station

• Open a new tab in your browser, enter the IP address of the Behnke Station in the address bar and log in.

• Click on "SIP Phone" in the menu. Scroll down to "SIP account 1" and select the option "yes" for "Register".

• Then fill in the fields with your peoplefone® SIP credentials as follows and click "Save" on the left.

  Field Behnke Station	Value peoplefone®
  Phone number/user name	SIP user
  User ID	SIP user
  Password	SIP password
  Server	pbxs.peoplefone.de
  Port	5061
  Server	TLS

  If the registration was successful, the "Registration state" changes to registered.

• Then click "Buttons" in the menu on the left. For the desired call button enter the extension number or phone number that is to be called when the button is pressed. Then click "Save" on the left.

• Click Save in the sidebar to save the configuration

• Wait a moment until the Behnke Station is reachable again

• If the registration is successful, the Registration state option changes to the value registered

• If this is not the case, please check the previous steps again

• Click the menu item Buttons in the sidebar to save the configuration
• Navigate to the section of the button to be configured, e.g. Button 1
• Set the Action option to the value Call
• In the input field of the Phone number option, enter the number that should be called when the button is pressed
• Click Save in the sidebar to save the configuration

The configuration of the Behnke Station was last updated for version 5.26.

2. Trouble shooting

3. Legal notices

Legal notices