Ask the wiki AIAI

Help for bintec-elmeg® be.IP plus

1. Setup guide

This setup guide describes how to put a Behnke Station into operation as a SIP subscriber on a bintec-elmeg® be.IP plus telephone system. In the following, it is assumed that the basic configuration of the bintec-elmeg® system has already been carried out, and we limit ourselves exclusively to the steps required to put the Behnke Station into operation.

It is assumed that the Behnke-Station is already set up to the extent that access to the web interface is possible. If this is not the case, please follow the instructions provided with your base electronics (manuals) and refer to the technical manualRecently updated — within the last 72 hoursUpdated to complete the basic setup.

1.1. Setting up the subscriber for the Behnke Station

The following section contains only the steps required to create a user. The setup may differ in your installation. If in doubt, please contact your PBX support.

• Open the management console of the bintec-elmeg® system.
• Log in with your administrator account.

• Scroll to the section TELEFONIE
• In the section TELEFONIE, click TELEFONIE at the bottom right

• Go to the top navigation bar.
• Click the menu item BENUTZER there.
• Go to the button NEU (bottom right) and click it.

• Choose values for name, description and password.
• Enter these values in the input fields Name, Beschreibung and Passwort.
• Make a note of these values; you will need them to configure the Behnke Station.
• Click the OK button at the bottom right to save the configuration.

• Go to the top navigation bar.
• Click the menu item INTERNE RUFNUMMERN there.
• Go to the button NEU (bottom right) and click it.

• Choose values for the internal phone number and description.
• Enter these values in the input fields Int. Rufnummer and Beschreibung.
• In the selection field Benutzer, select the user created in the previous step.
• Make a note of the phone number; it is needed to configure the Behnke Station.
• Click the OK button at the bottom right to save the configuration.

• Go to the top navigation bar.
• Click the menu item ENDGERÄTE there.
• Go to the button NEU (bottom right) and click it.

• Set the option Schnittstellentyp to the value VoIP.
• If necessary, select a Standort and enter a Beschreibung.
• In the section Interne Rufnummer, select the phone number created earlier.
• Click the OK button at the bottom right to save the configuration.

1.2. Configuring the Behnke Station

• Open your browser
• Access the Behnke Station web interface
• Log in

• Click the menu item in the sidebar.
• Navigate to the SIP Account 1 or SIP Account 2 section.
• Set the Register option to yes

• Use the assignments from the following table and enter the information in the corresponding input fields (in the SIP Account 1 section, if applicable SIP Account 2) of your Behnke station.
• Open your browser
• Go to the web interface of the Behnke Station
• Log in

• Click Save in the sidebar to save the configuration
• Wait a moment until the Behnke Station is reachable again
• If the registration is successful, the Registration state option changes to the value registered
• If this is not the case, please check the previous steps again

• Click the menu item Buttons in the sidebar to save the configuration
• Navigate to the section of the button to be configured, e.g. Button 1
• Set the Action option to the value Call
• In the input field of the Phone number option, enter the number that should be called when the button is pressed
• Click Save in the sidebar to save the configuration

The configuration of the Behnke Station was last updated for version 5.26.

2. FAQ