Ask the wiki AIAI

Help for Starface® Compact SIP v2

1. Setup guide

This setup guide describes how to put a Behnke Station into operation as a SIP subscriber on a STARFACE® COMPACT v2 telephone system. In the following, we assume that the basic configuration of the STARFACE® COMPACT v2 telephone system has already been carried out, and we limit ourselves exclusively to the steps required to put the Behnke Station into operation.

It is assumed that the Behnke-Station is already set up to the extent that access to the web interface is possible. If this is not the case, please follow the instructions provided with your base electronics (manuals) and refer to the technical manualRecently updated — within the last 72 hoursUpdated to complete the basic setup.

1.1. Setting up the subscriber for the Behnke Station

The following section contains only the steps required to create a user. The setup may differ in your installation. If in doubt, please contact your PBX support.

• Open the STARFACE® administration console in your browser.
• Log in with your administrator account.

• Go to the menu bar at the top.
• Click the menu item Admin.

• Go to the sidebar on the left.
• Click the menu item Telefone (Phones) there.

• Click the + button on the right.

• Choose a phone name and fill in the corresponding input field.
• Choose a password and enter it in the corresponding field.
• Make a note of this information, as it is needed to configure the Behnke Station.
• Switch to the Erweiterte Einstellungen (Advanced settings) tab.

• Go to the section Türsprechstelle (Door intercom).

• Activate the option Einschalten (Enable).

• If your Behnke Station has a camera, follow these steps:

  • In the field Kamera-URL (Camera URL), enter the address of the station's MJPG stream:

    http://<IP-Adresse der Behnke-Station>:8080/?key=<Passwort>&.mjpg
    

  • In the field DTMF, enter the code for opening the door. By default, this is 0#.

• Click Übernehmen (Apply) and then Speichern (Save).

• Go to the sidebar on the left.
• Click the menu item Benutzer (Users) there.

• Now click the + button on the right.

• Enter the following details:
  • Passwort (Password)
  • Nachname (Last name)
  • Vorname (First name)
  • E-Mail-Adresse (Email address)
• Choose an internal phone number.
• Go to the section Telefonzuordnung (Phone assignment).
• Assign the previously created phone to the user.
• Click Übernehmen (Apply) and then Speichern (Save).

1.2. Configuring the Behnke Station

• Open your browser
• Access the Behnke Station web interface
• Log in

• Click the menu item in the sidebar.
• Navigate to the SIP Account 1 or SIP Account 2 section.
• Set the Register option to yes

• Use the assignments from the following table and enter the information in the corresponding input fields (in the SIP Account 1 section, if applicable SIP Account 2) of your Behnke station.
• Open your browser
• Go to the web interface of the Behnke Station
• Log in

• Click Save in the sidebar to save the configuration
• Wait a moment until the Behnke Station is reachable again
• If the registration is successful, the Registration state option changes to the value registered
• If this is not the case, please check the previous steps again

• Click the menu item Buttons in the sidebar to save the configuration
• Navigate to the section of the button to be configured, e.g. Button 1
• Set the Action option to the value Call
• In the input field of the Phone number option, enter the number that should be called when the button is pressed
• Click Save in the sidebar to save the configuration

The configuration of the Behnke Station was last updated for version 5.26.

2. FAQ