Ask the wiki AIAI

Configuring a Static IP Address on the DNAKE A416 W Indoor Station

This setup guide describes how to assign a static IP address to a DNAKE A416 W indoor station.

1. Configuring the DNAKE A416 W Indoor Station

For the setup, we assign the following static IP addresses:

• DNAKE A 416: 192.168.0.10
• Behnke Station: 192.168.0.20

The goal is for the Behnke Station to call the IP address 192.168.0.10 when a button is pressed.

• After the DNAKE A 416 has started, swipe left.

• Select Settings.

• Select More.

• Enter the PIN (123456).

• Press OK.

• Select Ethernet.

• Enter the following data:

1. IP: 192.168.0.10
2. Subnet mask: 255.255.255.0
3. Gateway: 192.168.0.1.

Pressing the green arrow takes you automatically to the next field to be filled in.

• To save, press the checkmark.

• To confirm, enter the password (123456) again and confirm with OK.

Configuring a Static IP Address on the Behnke Station

• After the Behnke Station starts, it assigns itself a link-local address.

Link-local refers to the self-assignment of an IP address, intended for networks without a DHCP server. In this case, the device automatically assigns itself a free IP address in the range 169.254.0.0/16. The assigned IP address can be retrieved by pressing the configuration button twice.

• Assign the PC or notebook in the network an available link-local IP address that differs from the IP address of the door station. Otherwise, an IP address conflict may occur.

• First, open the IP address you determined in your browser and log in to the web interface of the Behnke Station with the user name 'Admin'.

• Select Buttons.

• Enter the IP address to be dialed under Button 1 Phone number. In our example: 192.168.0.10

• Set SIP phone/SIP direct call to Yes.

• Select Network and change the IP address assignment to static. Then enter:

1. IP address (example 192.168.0.20)
2. Network mask (example 255.255.255.0)
3. Gateway (example 192.168.0.10)
4. Save

Both devices should now have a static IP address.

• Register the Behnke Station with itself.

To do this, select SIP phone.

Set SIP account 1 to 'Yes' and enter the following information according to our example:

1. Phone number: 100
2. User ID: 100
3. Password: 100
4. SIP server: 192.168.0.20

• After saving, make sure it shows as registered.

2. FAQ